FUEL SAVING AND FUEL COMPONENTS

FUEL CAPS

FUEL SUPPLY UNITS

The fuel supply unit consists of a fuel pump (sometimes with a small pot), a filter, and a flange with corresponding connections.

In addition, the supply unit can be equipped with a lever-type sender, or can be used with a tubular type sender.

FUEL PUMPS WITH SWIRL POT

within a supply unit, a pump is installed into a swirl pot

FUEL PUMPS

The fuel pump is part of a fuel supply unit and located in the tank.

LEVER TYPE SENDER

Lever type senders are used to measure the fuel level in connection with an electrical display unit. Some senders are grounded. Senders without grounding have a separate ground connection.

TUBULAR TYPE SENDER

Tubular type senders are used to measure the fuel level in connection with an electrical display unit. Some senders are grounded.

Senders without grounding have a separate ground connection.

FUEL PRESSURE REGULATORS

Fuel pressure regulators maintain a defined fuel pressure. If pressure is exceeded a spring loaded membrane allows the return flow channel to open, permitting  excess fuel to flow back into the fuel tank.

PUMPS AND SENDERS

Speedometer Impulse Sender AUDI A4 A6 A8 QUATTRO

WE Also provide Pumps and Senders for other makes of vehicles

IDLE-SPEED CONTROLLERS

Idle-speed controllers provide dynamic adjustment of airflow in the throttle bypass valve, ensuring optimal idling at all times. Working in conjunction with the corresponding sensors and an electronic control unit, these devices provide a rapid response to any variation in idle speed.

SENDERS

An inherently reliable part, a fuel pump often goes unrecognized as a long-lasting performer until it leaves you stranded and it becomes clear that even the most reliable parts have a life span.

Our mechanical fuel pump for carbureted models comes with one gasket, but if you can't remember the last time you had the fuel pump off, it's a good idea to replace the spacer and purchase a second gasket. Lucky for you, our mechanical fuel pump kit has everything you'll need for a complete replacement.

FUEL FLOW SENDER

• Single range fuel flow sender optimized for flow rates up to approximately 50 liters/hour. Compatible with 4-6mm ID hoses and similar imperial sized hoses.
• Compatible with a wide range of fuels including those with methanol and alcohol content.
• Mechanical failure of the sender will not block the fuel flow

FUEL LEVEL SENDER

This is a typical fuel level sender kit available from TAS. These kits come in many forms and types. You can use any resistive type sender with our instruments and you can also use capacitive probes if they have a voltage level output.

We do not supply these items due to weight considerations and freight costs. Please obtain these items from your local suppliers.
We recommend VDO level sender for our instruments.

BODY FUEL FLOW SENDER

Multi Range fuel flow sender.
Using one of four supplied restrictor jets up to five flow ranges can be catered for.
Fuel flow measurements from 3 liters/hour to as much as 500 liters/hour can be achieved.

FLOWSCAN FUEL FLOW SENDER: Fuel Flow Sender

Metal body fuel flow sender
Popular choice for larger aircraft
Uses standard AN fittings
Stocked as standard, other flow ranges on request

GEAR TOOTH SPEED SENSOR

FIVE kinds SPEED SENSORS can be selected:

• magnetic pick-up speed sensor, no power. output voltage signal.
• hall-effect speed sensor, only for speed ferrous gear target.
• hall-effect speed sensor, only for speed multipolar magnet target.
• hall-effect dual channel speed sensor, both speed and motion direction for speed ferrous gear target.

FUEL PRESSURE SENDER T-FITTING ADAPTOR

Install your fuel pressure sender with ease using our adaptor that can be quickly installed into any rubber fuel line. 

This can also be used for oil cooler lines to add our Oil pressure sender or oil temp senders.

VDO FUEL SENDERS

Not sure how much fuel is in the tank? If your sending unit is original, that means it’s “reaching it’s golden years.”

The common “starting to fail” symptom is an inaccurate gauge that momentarily pegs at full. It might work like this for years - and it might not last another week. Put an end to uncertainty and prevent unwanted rest stops by the side of the road due to an empty tank.

FUEL PUMP MODULE: HONDA CIVICS

Honda Civic Fuel pump module assemblies provide original equipment-style fit and performance and feature a variety of design enhancements engineered to ensure long, trouble-free service life.

Each assembly is 100% performance tested before it is approved for shipping.

AUTOMOTIVE FUEL PUMP MODULE

Internal springs increased durability and enhanced stability prevents tube chafing. Lower amperage draws fewer load on vehicle's electrical system.

Fuel level gold-filled sensors provide improved resistance to sulfur corrosion and heat resistance; Empty float height and float retention is to exact OE specifications guaranteeing correct gas gauge reading.

ELECTRIC FUEL PUMP AUDI A4

TAS has a wide selection of auto parts, including Audi parts! If you're looking for 2004 Audi A4 Fuel Pump parts, you've found the correct section of our website - hopefully you see the parts you need listed here. If you don't see what you are looking for, Please contact us to see if we have any in stock.

SUPPLY UNITS Fuel Injection Throttle Body

A fuel injection throttle body is a component in the air intake system in fuel injected engines that controls the amount of air that flows into the engine.
Its largest piece is the throttle plate which regulates the airflow. When the accelerator pedal is pressed, the throttle plate rotates, which creates an opening for the air to flow into the intake manifold. The amount of air is then measured by the airflow sensor and sends the signal to the ECU, which then analyzes the data and adjusts the amount of fuel being sent to the fuel injectors to achieve the desired air-fuel ratio.